hey guys, so i have a bliss v2 rebuildable atomizer, and every time i put it on the ohm meter or even on the vamo to read the ohms, it reads "1" on the ohm meter and "9.99" on the vamo. So i rebuilt this atomizer, all coils are firing equally. its all screwed onto the positive and negative connectors fine. When I fire it up, it produces good vapor and excellent flavor using 5 wrap 30 gauge on a SS cable wire (wrapped wit SS mesh on the top). everything is lighting and working fine, except my ohms meters won't read it. The bottom connector (male connector) on the atty seems like it may have gotten pushed it just a slight mm or 2. can this be the reason why its not being able to read on the ohm meter? by not making full contact? need help and want to know if it is still safe to vape. thanks everyone.
- Status
what mod are you planning to run on variable voltage? I had similar setup and it did fine on the provari, stay away from eVic on this setup tho...
The bliss has an adjustable post. What i do is screw it on to my mod, back it off half a turn then put the top screw against the wall and push slowly but firmly. You should be able to feel the post move. Ideally you should do this before you install your wick and definitely with an empty tank.
Its my favorite atty but that positive post moves too easily. If you overtighten it on the mod, the post gets pushed back in easily. Gets annoying sometimes.
Hope this helps
Its my favorite atty but that positive post moves too easily. If you overtighten it on the mod, the post gets pushed back in easily. Gets annoying sometimes.
Hope this helps
Yep i put the top screw to the wall and push the center post down so it makes contact with the pin on the mod. Make sure you unscrew the atty no kore than half a turn or you will push the center post down too far
- Status
Similar threads
- Locked
