I have a Riva 510 and use the blue foam mod for the filter. My question is should I just put 5-6 drops at the end or fill up the cartridge first, insert the foam, and then add a couple of drops at the end? Will the atomizer be able to vaporize the liquid at the bottom of the foam? Does it last a lot longer and does all the liquid actually reach the atomizer?
Blue Foam question
- Thread starter HoustonHacker
- Start date
- th_trl_thread_readers 0
- Status
Borrowed from a Strictly ejuice page:
https://strictlyejuice.com/index.ph...ducts_id=222&zenid=ejg468te2ausoj4tc5phpppq81
https://strictlyejuice.com/index.ph...ducts_id=222&zenid=ejg468te2ausoj4tc5phpppq81
I don't fill to near the top - tempting fate to put too much juice in a cart. I would fill 1/2 way, or 2/3 of the way if I felt daring, then insert the tapered end of the foam and press the foam down into the liquid to wet the foam. Then reposition the foam at the top edge, then top it off with 2-3 drops or whatever it needs to look damp but not a puddle.
Mostly I just don't use carts though. I either dripping to test juices and Boge cartomizers to vape the ones I like.
Mostly I just don't use carts though. I either dripping to test juices and Boge cartomizers to vape the ones I like.
I use bathroom sponge and cut it so its a loose fit, e-juice is thicker than water and as long as you dont overfill it wont leak,just my 2 cents worth
But will the atty suck up all that juice at the bottom of the filter? I know when my vapor starts going away and I add more drops, the foam is still wet.
welocome to ECF Houston, I think you have all the advice given, fill firtst insert the fluval or blue foam and then you can top off if you like.
i cant find it in Spain so lightly fiited sponge does it for me and it doesnt melt, but i keep it well damped with fluid
What type of Cartridge are you all referring too? I have an eGo with Mega blank carts with the original white fill in them. Should I remove the filling paper and fill my carts? I have just been dripping my juice onto the poly-fill until it is some what soaked in juice then add a few drops on the atty and vape it.
I'm still waitng for my blue foam to get here and then i can find out if they retain the last drop or not(in response to ur second or 3rd question. As to the white filler iv noticed it tends to taste bad after numerous refills, so yes u need to replace it. just my 2 cents.
I am currently using a smart cart style cup cartridge its what came with the mega t-rex from LF. I quickly switched to the blue foam and have settled on the Blue Foam Dart as outlined in the Modders Forum. This method for me shows the most fluid usage of all with the blue foam. When i fill/refill i fill the cup 2/3 to 3/4 of the way up to the top place the dart in the cup and position the foam so that its at or below the top edge of the cup. if the foam still looks dry after absorbing the fluid from the cup i place 2-3 more drops so that it looks mushy but not pooled. hope this helps!
The filler pre-installed in carts is generally inferior. Blue foam is better; tea bag mods are better still:
That said, my own experience is that among the big 3—carts, cartos and dripping—carts are the least effective. Before you go to the trouble of cutting up a tea bag, I'd recommend pulling out the filler entirely and try direct dripping, if just for the eye-opening flavor.
- Status
Similar threads
- Locked
