Bottom feed rda

[Vape Newbee]

I have a Dovpo X TVC Topside 90W Squonk Box mod. Can someone please recommend a single coil bottom feed tank for Squonking. Thank you

 

[icepickmaker84]

The Wasp Nano, VV Pulse v2 with single coil insert, and the Axial would be my top 3 bf rda’s. The Dead Rabbit SQ is also a good single coil bf rda. For an actual bf tank I like the VV Pyro v2, squonking the tank full is satisfying.

 

[Vape Newbee]

Thank you

 

[Vape Newbee]

The Wasp Nano, VV Pulse v2 with single coil insert, and the Axial would be my top 3 bf rda’s. The Dead Rabbit SQ is also a good single coil bf rda. For an actual bf tank I like the VV Pyro v2, squonking the tank full is satisfying.

Can you recommend a coil brand and ohm for this setup. Thank you

 

[icepickmaker84]

I vape anywhere from .15 to .3, typically in the Topside I’d go on the .3 side. I’ve had could results with GeekVape and Vandy Vape premise Clapton wire as well as some prebuilt coils from Amazon. The coils that come the Pulse v2 are really nice.

 

[madstabber]

I have a Dovpo X TVC Topside 90W Squonk Box Mod. Can someone please recommend a single coil bottom feed tank for Squonking. Thank you

The Wotofo Profile bottom fed RDA is an excellent choice if you like lots of flavor. Either Profile will work, there isn’t a big difference between the two performance-wise. Can’t go wrong with either one and get a spool of mesh or you can get the factory pre-cut stuff. Being you use so few mesh strips and they cost so little makes sense to go with convenience and get the nexmesh mesh

 

[AngeNZ]

Have a look through this thread:
Flavour Banger Single Coil BF RDAs/RDTAs
Lots of single coil bf RDAs that give great flavour

 

[Don29palms]

 

[RuiG]

Merge threads please Bottom feed tank

 

[mimöschen]

I'd vote for the Wotofo Ryujin Elder Dragon or the Reload S.

 

[Zenvaper84]

The new vandy vape mesh v2 is made for sqounking. The juice well is deep and its easy to build plus vandy vape mesh coils are cheaper and better imo than nexmesh. Although the sqounk pin doesn't come installed and is kinda a pain to do but worth it.Obviously subjective

 

[Falconeer]

Origen Little clone ( the original Origens aren't available any more ) - great squonking attie for flavour and it can be built either as a double or single coil. IMHO when built with a single coil of around 1 Ohm it works best with the coil located between the posts.

I had the original and the clone but both went AWOL in the move back from Spain recently - I have just ordered another clone and expect it this week.

Oops sorry - re reading your post I see you want a tank.

 

[DonBaldy]

the Wotofo Ryujin Elder Dragon is an excellent choice. The Axial from Mass Mods/Unicorn Vapes is also a really nice one. It can also be used as a dual coil if you choose. Axial can still be had for $10 at Arkansas eliquid. If you want to spend a little more then the KRMA is a terrific single coil flavor atty.