Build recommendations for gi2

Status
Not open for further replies.

ScarAH

Full Member
Jun 2, 2014
14
1
Tennessee
So for my birthday I'm getting hooked up with a sweet deal on a gi2. I primarily vape a munstro with a crest cap Igo 5 at about .3 ohms with dual 24g macro coils. I've had little experience with vv/vw mods so I was looking for any suggestions on how to get an awesome vape with a vv/vw device. Advice on anything from builds to power settings to wicking would be very appreciated. Thanks for the help.
 

steved5600

Ultra Member
ECF Veteran
Verified Member
Sep 7, 2012
2,693
1,197
Dallas, Texas
Love the display on them. That mod will not go below .4 ohms. So what I would do go with your best dripper quad coils so 7-8 turns of 28 ga a1 kanthal 3mm dia wraps should give you that. IMO I prefer vertical coils. Use Japanese cotton if you can get it. Last longer than rayon an is much better at wicking. I think the reason it last so long is that it wicks so good that unless you let it run dry it does not burn the cotton. Then run it at what ever wattage the atty/wicking will support.
 
Status
Not open for further replies.

Users who are viewing this thread