The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Building coils for 2x 3.0v battery setups.

Discussion in 'Coil Builds' started by Extremeodd, Dec 2, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Extremeodd

    Extremeodd Senior Member Verified Member ECF Veteran

    Mar 9, 2009
    Ive been looking at getting an Igo-w for some time now and need some quick advice before ordering supplies. The current setup I use is a smoktech bolt with 2x 3.0v lifepo4 cr123a's with dual coil 2ohm tank cartos. Im wanting to move towards something with more flavor and stronger vapor production, RDAs seem to fit the bill. However every build I see is for IMR 3.7v batteries, usually subohm. Sadly I cant quite go that route on these batteries, they tend to max out at roughly 3 amps output. So I'm definitely looking at thinner wire (30-32g) to keep the number of wraps sane on a dual coil build. How feasable is it to stuff 2 4ohm coils (30-32g) into an igo-w, or would there be a more optimal coil setup for what I have?
  2. State O' Flux

    State O' Flux Vaping Master Verified Member ECF Veteran

    Jul 17, 2013
    Here... this chart, compiled by "ancient puffer" might offer some pointers.
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice