How long should these last ? Mine only last just over a day. Had favour and tank was warm but no vapour so thought it must be coil. Put new one in and it's fine. Maybe I'm using to high a volt. Around 4.3-4.5. Is that to much ?
BVC coil
- Thread starter angie124
- Start date
- th_trl_thread_readers 0
- Status
Hi Angie
I run a 1.8 ohm on 3.7/3.8.But that's not saying it's the right thing to do,just works for me.
I run a 1.8 ohm on 3.7/3.8.But that's not saying it's the right thing to do,just works for me.
For me, I look for the drop in Vapor when taking a draw. I cleaned a BVC coil the way I do other coils and it helps, but is not like new. I figure that I can do a rinse under HOT water in an emergency, but, I tend to just replace them. I have been doing about 25ml before they lose their vapor. Viscosity of the juice does make a big difference. Heavier VG ratio is the culprit, I think.
Hope helps
Hope helps
Sometimes it feels like there is a blockage half way through a draw. Anyone know what would cause it ?
http://www.e-cigarette-forum.com/forum/variable-voltage-apv-discussion/601111-eleaf-istick-419.html
Look at post #4187,so the answer could be 3 volts.
Look at post #4187,so the answer could be 3 volts.
I get that now and then if one of my fingers inadvertently covers some or all of the airflow, usually happens pre-inhale but I have done it mid-vape too.
I've used five so far with two different tanks; two working at the moment, nearly new; two lasted pretty well (2-3 weeks); one died with a gurgle after about an hour.
I have heard a lot of people complaining about quality control re the aspire BVC over various threads.
Due to this and that I am a skinflint I have stuck with Kanger gear and re-build all my own coils. have just started building vertical coils in my old kanger heads and the vape is amazing. Can also build them in the new upgraded enclosed heads.
Here is a thread I posted on how to do it
http://www.e-cigarette-forum.com/fo...ed-kanger-dual-coil-single-vertical-coil.html
I find that building your own is more reliable than buying stock coils due to lack of Q.C.
Due to this and that I am a skinflint I have stuck with Kanger gear and re-build all my own coils. have just started building vertical coils in my old kanger heads and the vape is amazing. Can also build them in the new upgraded enclosed heads.
Here is a thread I posted on how to do it
http://www.e-cigarette-forum.com/fo...ed-kanger-dual-coil-single-vertical-coil.html
I find that building your own is more reliable than buying stock coils due to lack of Q.C.
- Status
Similar threads
