Cartomizer Labeling

Status
Not open for further replies.

candre23

Ultra Member
ECF Veteran
Mar 12, 2010
1,185
23
NJ
chipandre.com
Do you have a label maker? If it's one of the better ones, check to see if it has a "rotate and repeat" mode. This turns the text 90 degrees and repeats it down a specified length of label. It's very useful for labeling wires, pipes, or anything else round. Like a cartomizer. I have a Brother PT-1650 and the labels it prints on 1" tape are perfect for labeling cartos. They do make it a bit more difficult to put the condoms on the connector end, but it's still doable. I am using heavy-duty vinyl tape, so the regular thin cellophane stuff would probably be easier.


labeled.jpg
 

woolfe99

Senior Member
ECF Veteran
Apr 14, 2010
211
50
57
San Francisco
Thanks for all the good suggestions. I'll pick one of them.

I have another, related question. Is there any drawback to using atomizers as cartridge plugs? I have right now 7 atties and 6 flavors, so I have enough. I was thinking about doing this to avoid the problem of using 1 atty for multiple different flavors and having 1 flavor bleed into the next. Some of these flavors never seem to go away after I switch.

- wolf
 

Scorched

Super Member
ECF Veteran
Mar 25, 2010
402
20
Denver, Colorado
That looks intresting, I will definelty need to get a label printing device sometime in the near future. Wouldn't it be easier to put the label around the cartomizer caps instead of on the cartomizer itself? I would find it weird vaping with a big label on my cartridge for everyone to see.

For now I am looking for a temporary fix. A regular marker doesn't seem to stay on the cartomizer caps very well. Any suggestions?
 

candre23

Ultra Member
ECF Veteran
Mar 12, 2010
1,185
23
NJ
chipandre.com
Wouldn't it be easier to put the label around the cartomizer caps instead of on the cartomizer itself?
If you always keep the cap with the carto, then probably. I don't. I have a carto on my bartleby and a couple extras with caps in my pocket. When one runs out, I take the caps off a full carto, stick them on the empty, and go. If I labeled the caps, they'd be all mixed up in no time.
 
Status
Not open for further replies.

Users who are viewing this thread