Cartomizer Question

[Winchester]

Is there a way to test Boge SR 510 cartomizer before use.

 

[Covert]

Yes break out your Fluke set it to read Ohms put the positive probe in the middle of the threaded end of the carto, and then put the negative probe on the threads of the carto if it does not read then the coil is bad or your not getting the probes in the proper place. Your most likely using SR (Standard Resistance) cartos they should read anywhere from 2.2 to 3.0 ohms depending on brand if they are working.

 

[Steam Turbine]

whatever you do.... dont fire em dry!

 

[Bill's Magic Vapor]

Well, there you have it. Two previous posts covered my thinking. Good job.

 

[Winchester]

Hello Guys,

Thanks for the info! That really helps a lot!