Catfish atty mods.
- Thread starter Chowderhead1972
- Start date
- th_trl_thread_readers 0
- Status
With all of the top shelf attys and mods you have your still using L wrenches? C'mon man; step your vape game up! Just so you can get it over with you will need the following Hudy drivers:
.035- Cyclone, Reactor, Divo
.090- most three post attys other than the above list- Quasar, Stillare, Atomic, etc
1.5mm Zenith
#0 Phillips.
Hey CH! I've gotten used to my magma and love it! But still prefer the smaller diameters. Divo is a bit out of my price range. Do you have any atomics left? I get that and the reactor mixed up for some reason. The atomic is the smaller of the 2 right?
The answer is really just a couple of posts up....
Sent from my Transformer TF101 using Tapatalk
Too early to dibs a Reactor? If not, can I dibs one, pretty please. [emoji120]
Didn't I see somewhere around here where someone had done an adjustable one for the Divo? Having no luck turning up the thread, now.
Note that my observation on the AFC Cyclone flavor wasn't actually a complaint. I'm really loving this thing (and kudos again to CH on the perfectly functioning mod.) I hadn't actually fiddled with the afc, yesterday, beyond getting the draw to where I'm used to having it. Today, with a more familiar juice loaded, I unexpectedly discovered that opening the airflow up actually increased the flavor, contrary to what I was expecting. I've got the single coil about as close to the air hole as it can get without a short, so maybe the greater airflow was necessary. Also smoothed out some of the aggressiveness of the throat hit.
I'm still a pretty new vaper, and the only experience I've had with afc prior to this has been on Kanger Aerotanks. On those, opening up the aiirflow anything past tight just kinda sucks, so having it be an improvement is a revelation.
That's the one I got!! Kind of pricey but when you have old eyes it's worth twice the price!
Turbocad made an adjustable chamber reducer for the cyclone AFC but there's nothing production... Yet.
I would gladly buy ten of them if he needs a push or some seed money... Although my 2013 Cyclone/AFC supply is nearing the end...
what at material did he use? It would need to be heat proof and dielectric, glass, Pyrex?
Does anyone have interest in regular Plumeveil clones? Not bottom fed, not able to be bottom fed, my supplier is giving me the blues about returning them, thinking I will sell them at my cost. These are NOT Infinite clones. I have 10 of them and will let them go for $12 each. These could be bushing modded for bf but not by me. I don't do bushing modded attys.
Shipping is an extra $3 for one plume by itself, buy two shipping is on me...
I still have 8 left....
Shipping is an extra $3 for one plume by itself, buy two shipping is on me...
I still have 8 left....
Last edited:
he used a chunk of teflon if i recall, but peek and all that would be better.
T
T
I will take two of the $12 el-cheapo Plumeveils... Payment SENT & PMed
Can anyone recommend (or have for sale) a good cheap mech mod that would look decent with a Plumeveil on top?
- Status
