Changes in Ohms?

[Lurch]

Have a 26ga coil (Russian) that initially was reading 1.9 Yesterday I did a dry burn and re-wicked. Put everything back together and was getting a 1.01 reading. Took it apart again, made sure everything was hooked up right, made sure coils were still straight, etc. Put it back together and then was receiving 1.4 reading.

Any idea why?

 

[NickWhit1992]

Have a 26ga coil (Russian) that initially was reading 1.9 Yesterday I did a dry burn and re-wicked. Put everything back together and was getting a 1.01 reading. Took it apart again, made sure everything was hooked up right, made sure coils were still straight, etc. Put it back together and then was receiving 1.4 reading.

Any idea why?

Are you reading it on an ohm meter or on a mod?

 

[vampyrex13]

Loose screw? Juice on the 510 connector?

 

[propofokgov]

^ + Coil warped when burnt, corrosion on the coil, juice in the atty, ohm meter contact is moving, humidity in the air, solar flare, Kim Jong Un willed it to change.

 

[Lurch]

All testing done via my ProVari. Checked pin to make sure everything was clean...

I was a little concerned about Kim Jong Un being involved, may have to investigate that a little further....

 

[NickWhit1992]

Do have have another atty you can test, see if it's jumping too?

Sent from my HTC One