CHecking resistance using MVP

[DrZombi]

Hi, lil noob question here, is it safe and pretty accurate to check the resistance of a rba build on the MVP2 with the resistance check option on the device?
thanx in advance

 

[EBates]

It's not the most accurate but lots of folks do it. IMO, don't trust it for sub ohm builds.

 

[Kloudz]

I do it when I'm building a coil on my Provari. Hopefully Santa will bring me a much needed ohm reader.

 

[DrZombi]

thanx all, im getting into rebuildable and Im aiming for around 1,5 for my 1st build, single coil so I'll assume its safe to use the mvp for that matter!