CHOPPERSTYLE Powdercoating & Polishing and More for YOUR MODS Service

Status
Not open for further replies.

chopperguys

Unregistered Supplier
ECF Veteran
Nov 20, 2011
828
1,659
south jersey NJ USA
powder coating is here.
1. Pick whatever color you like from powder by the pound and have it shipped to me.
Powder Coating Powder-Powder Coating Colors-Powder Coating Paint
2. Then send your mod so i can powdercoat it the color you want.
3. I then send it back

prices for now will start at 25 per for tube style and reo stlye

mods must be able to be taken apart so pm me what mod you have to see if it can be powdercoated first

shipping and any paypal fees you have to pay

ok let get some done thanks guys and gals

polishing starts also at 25
 

chopperguys

Unregistered Supplier
ECF Veteran
Nov 20, 2011
828
1,659
south jersey NJ USA
lol mixing the powders is going to be an experience by itself that you may end up cursing me over LOL

Oh with the masking I am asking is it posslbe to powder coat 4 times, meaing a base coat, a primary masking layer, a secondary masking layer, and then the clear coat?


(and it would be a lot easier to apply the layers in reverse order, just adding decals to the piece after each coating, stripping the tape of then clear coating it.)

Oh so yea my logo is my avatar the green three eyed earth anja. I have am debating between 6 different color schemes each one a more complex powder mix then the one before it....If I can do the multiple stages to the paint I am gonna be so much more excited about this then I already am.


i don't really know where to start but here goes

the powder purchase sounds like a lot but when you put it in the bottle on the gun its a half of bottle and the setting up the gun for spray uses some then coating the piece and after there is waste in the gun so there is a little left but not much maybe enough for some little samples in no way is 1lb enough to do a half of car powder coating is like 75% waste in overspray with that said next

i can not do 4 layers of powder coat it will chip very easy we can do your logo in the base color by making a decal with decal girl and clear over the whole thing for protection i have also been thinking of doing these with decals I'm gonna call it

TATTOOS FOR YOUR MODS
 

chopperguys

Unregistered Supplier
ECF Veteran
Nov 20, 2011
828
1,659
south jersey NJ USA
chopper, not sure if you seen my post about powder coating the outside of an Alpha Ultra with the RES. Do you think this is possible or would it chip off the areas where is screws together easily

i think it will be fine all the silver bullets and bb's are powder coated and they are fine and also the rough stacks
 

chopperguys

Unregistered Supplier
ECF Veteran
Nov 20, 2011
828
1,659
south jersey NJ USA
What's up Chop. My wife is still debating on a couple diff. colors. I wanna High Jack her SB and get it done myself! haha She wants a purple of some sort. It will still look Rad though. That's for sure. Just waiting on a couple things and we're sendin it your way man;)

cool very cool coil
 
Status
Not open for further replies.

Users who are viewing this thread