Cleaning 901 atomiser with alcohol without damaging paint?

[No burn baby]

Can anyone kindly give me some tips as to how I can clean my 901 atomisers with isopropyl alcohol without damaging the paint? What end do i drip it into and, presumably, it will drip right out the otherside right?

Then do I need to reprime them some how? I don't drip, I use carts.

Thank you!

 

[dave1212]

That stuff is toxic to ingest, don't do it!

 

[shawnp1]

i personally prefer to boil mine. then blow them out, let them dry, since u dont drip u could pop in a cart after it is dried out an let it sit for awhile to soak up some of the liquid to kind of reprime it.

 

[No burn baby]

Thank you. But won't boiling destroy the plastic coating/design?

 

[Lurker]

That stuff is toxic to ingest, don't do it!

Seems a fairly common practice. I've done a few in alcohol. Not sure what to say about the paint. You will probably be replacing those parts soon anyways.

http://www.e-cigarette-forum.com/forum/tips-tricks/2175-cleaning-atomizer.html

 

[shawnp1]

boiling has never damaged the finish on any of my pieces. but i cant garuntee it wont hurt the finish

 

[SANJP]

My Top Atomiser Cleaning Tips

1. PLAIN OLD RUN UNDER HOT TAP AND LEAVE TO DRY

2. DISTILLED VINEGAR FILL SMALL CUP SOAK RINSE AND LEAVE TO DRY

3. BLOW THROUGH HARD WITH TISSUE AT CART END ,THEN RE USE

4. COMPRESSED AIR, BLOW THROUGH WITH A AIR COMPRESSOR.

5. BOIL SOME WATER PLACE ATOMISER IN FOR 10 MINS THEN DRY AND RE-USE

NEXT TIP REQUIRES EXTERNAL MANUAL SWITCH BATTERY

5. BLOW EXCESS FLUID OUT THEN HEAT ATOMISER USING MANUAL BUTTON OR SWITCH TILL JUST GLOWING RED(NOT FOR MORE THAN 1 SEC ARE YOU MAY KILL ATOMISER) REPEAT ONCE MORE AND YOU DONE.


HOPE THIS QUICK GUIDE HELPS YOU OUT

 

[No burn baby]

Thankyou!!!!!!!!