I just don't get it! I have been going down that path of lower ohm builds for a few months now with my new mech's and rba's but for my kayfun's mostly have settled on 28 gauge kanthal 1 ohm coil build wrapped around a figure of 8 and a paper clip. I tried micro coils and chimney coils and various cotton sculptures with varying degrees of success...then
Today I used some 30 gauge wire and made a micro coil of 7 wraps and attached it to the kayfun lite..oh poop, it came out at 3 ohms. Oh well, I carefully wicked it with a fluffy chunk of organic cotton; juiced it up and to my surprise it produced a substantial warm cloud of tasty vapour!!
I admit that I used more than 4 volts on an MVP but presto! same happy result as with a 1 ohm coil.
How did this happen?
Today I used some 30 gauge wire and made a micro coil of 7 wraps and attached it to the kayfun lite..oh poop, it came out at 3 ohms. Oh well, I carefully wicked it with a fluffy chunk of organic cotton; juiced it up and to my surprise it produced a substantial warm cloud of tasty vapour!!
I admit that I used more than 4 volts on an MVP but presto! same happy result as with a 1 ohm coil.
How did this happen?