wound a SS316L coil for my NarDA clone. misjudged the width slightly (measure you say? of course not!) but managed to cram it in there. 3mm ID @ 0.3ohms (8 wraps?) and it fired up evenly almost instantly...well after 2 pulses.
i can confirm the vapeage is good . only used it in wattage mode so far but when i change out the squonk pin it'll get some TC lovin'. it ramps up super quick at 35W. wicked with rayon...natch.
if you do try it do let us know what you think. i've never used cotton since i first wicked with it.
the narda? i suppose it's a restricted lung hit. bit like my dead rabbit slightly more than half closed. the air holes are only a couple of mm wide. as can be seen, sort of, here (on a coppervape squonker)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.