Constant high ohm reading on bigboxatlas

[dms25]

Hi,
My innokin bigbox atlas is constantly reading my resistances 0.2ohms higher than any of my other mods. I've cleaned the connection and can't guess what the problem could be, any ideas?

 

[QcVaper]

different chipset =variation in resistance a 0.02 difference is normal but if it's really a .2 (like from 0.2 to 0.4) that's not .

 

[stols001]

My teslacigs mods do read a bit different than some of my other mods, I'm inclined to think it's probably the board doing it. Since it's been totally consistent, and I've had no problems with it whatsoever, so I just accept it as the idiosyncrasy of the board.

0.2 is not outside the realm of possibility, IMO, but if it's been doing it since the beginning (its not something new) and if you've been vaping fine, well, that might be a sign that it's okay.

I don't want to give you bad advice and really you will have to decide for yourself, whether that variance is acceptable to you but it's not unusual for mods to offer different readings on coils, etc.

So, that's kind of what I have to say about that.

Good.

Anna

 

[dms25]

It was not so since the beginning, it used to give me readings on par with my other devices.

Using wattage mode I was getting burnt hits, I switched to TC and it's working fine...

Just wondering if it could be a warranty issue and if I should send it back?

 

[stols001]

I guess I'd be concerned if it's a new problem and it didn't act that way before. I mean, it could be a sign of early electrical issues starting. If it were me I might contact the vendor and explain what is going on, so that if you need to warranty it, you can. Etc.

Anna