Cracks in RN4084 carts?

[PRoPAiN!]

Hope this is the right place, as it seems to be the only place I can post!

I keep getting cracks in my carts. They tend to be oriented along the length of the cart, along what I would perceive to be the "grain" if they were to be manufactured by extrusion. Just needing to know what might be causing them. I'm guessing it's one of the following:

• Stress from heating and cooling
• Sliding them on the atty at slight angles and with a little too much force (read: "in a hurry")
• Carts getting brittle over time (possible reaction between PG and whatever plastic these are made of?)

 

[suhrim21]

Hope this is the right place, as it seems to be the only place I can post!

I keep getting cracks in my carts. They tend to be oriented along the length of the cart, along what I would perceive to be the "grain" if they were to be manufactured by extrusion. Just needing to know what might be causing them. I'm guessing it's one of the following:

• Stress from heating and cooling
• Sliding them on the atty at slight angles and with a little too much force (read: "in a hurry")
• Carts getting brittle over time (possible reaction between PG and whatever plastic these are made of?)

I have thrown away 4 cartridges due to the same problem. I think it just might be heat issue. I noticed it happend only when I was chain vaping on mine.

 

[PRoPAiN!]

I have thrown away 4 cartridges due to the same problem. I think it just might be heat issue. I noticed it happend only when I was chain vaping on mine.

I constantly chain vape, so I guess I'll need to stock up on carts. thanks for the input!

 

[suhrim21]

I constantly chain vape, so I guess I'll need to stock up on carts. thanks for the input!

I cant tell you that that is the reason I can only tell you my experience. I could be dead wrong but I just give what I have noticed.