DCT MAP - What am I doing wrong?

Status
Not open for further replies.

dave_101

Full Member
Dec 31, 2010
21
1
Australia
Hey Everyone,

Grabbed myself a couple of DCT MAP tanks and I am having problems. Are they meant to gurgle all the time?

It's like the carto is flooded and no matter what amount of juice I have in the tank they gurgle and at times spit juice in my mouth.

I tried sliding the tank up the carto so the holes in the carto were no longer in the juice to try and stop it flooding and dry it out with vaping, but seems the juice can even make it down the sides.

So far today I have had two completely flood and piss juice out the ends and gurgle and spray juice in my mouth.

Any feedback or how I might not be using them correctly would be soooo welcomed. lol
 

rtrain99

Ultra Member
ECF Veteran
Verified Member
May 25, 2009
1,331
785
The 808 state
you should prime the carto before you install it in the tank. you should not drip through center hole when priming. If you don't know how to prime your carto check out electronicstix for tutorial. I made the mistake before by dripping straight through my drip tip thus dripping into the middle hole of the carto. I got the same gurgle and spitting. So just remember, prime the carto correctly and don't cover the holes on the sides of a punched carto. (note: I use a J tank, same concept as the DCT Map tank)
 

dave_101

Full Member
Dec 31, 2010
21
1
Australia
Thanks for the replies guys. :)

It's more like the carto is flooding, maybe the two holes are to many but it does not seem like other people with the same setups are having the same issues.

It's all good though as I think I am going to swap back to CE2 tanks, been getting a little worried about carto's burning and the vapor coming off the CE2 tanks does feel a lot cleaner than the carto ones.

Thanks all for taking the time to reply, means a lot. Now I am off to make a thread to see if I can get info on the very best CE2 tank mods out there. :p
 
Status
Not open for further replies.

Users who are viewing this thread