Ok so i like the size of ikenvapes hv801 mini atomizer but was aggravated because you can not istall a drip tip in it since the bridge is so close to the top of it. After seeing phee's video on debridging i thought this was the soultion. Only problem was the ammount of juice that would leak down the holes where the wires to the coil came in.
Now i could drip once then vape but thats was also a pain to me.
so what i did was take the filling out of a cartomizer and install it in the space beside the coils.
This allows me to drip my normal 4-5 drips directly onto the coils and vape as i was before, and also reduces the temp. of the "hot" vapor you get when debridging at high voltage. I get no burnt taste and the filling is not burning as long as you keep it wet. and if it does you can easily remove the filling and put new in. I get no leakage or bubbling anymore and the flavor is perfect.
so what do you guys think? any problems with this? good idea?
Now i could drip once then vape but thats was also a pain to me.
so what i did was take the filling out of a cartomizer and install it in the space beside the coils.
This allows me to drip my normal 4-5 drips directly onto the coils and vape as i was before, and also reduces the temp. of the "hot" vapor you get when debridging at high voltage. I get no burnt taste and the filling is not burning as long as you keep it wet. and if it does you can easily remove the filling and put new in. I get no leakage or bubbling anymore and the flavor is perfect.
so what do you guys think? any problems with this? good idea?
