Delta 2 on a hybrid mod?

[KEN47]

The delta 2 contact sticks out almost as far as my rda does. Is it safe to use on a SMPL hybrid top cap mod?

 

[Wolfenstark]

Can you push the 510 pin back to be flush or close with the outside threads ?
If so then No.

I wouldn't use my subtank mini on my smpl.

 

[Susan~S]

I wouldn't risk it -- I have a Delta II. Hybrid Top Caps & Battery Failure

 

[Completely Average]

Of the subohm tanks that are out there the Delta II is one of the safer ones for use on a hybrid mod. The positive pin in the 510 connector is non-adjustable, so it's not going to collapse or move.

It's a touchy question that really has no good answer. The pin does extend beyond the 510 connector and it does not move so it may work fine. You can try it, but be very aware if you do that it's possible to create a short.

My advice is that IF you decide to try it, screw it on gently and then immediately remove it and check the atty and battery for any temperature increases. If anything got warm then it shorted and you should not attempt to use it again. This is a very "iffy" setup in regards to safety. If you decide to try it always be extra cautious and on the lookout for any signs of a short.

 

[edyle]

The delta 2 contact sticks out almost as far as my rda does. Is it safe to use on a SMPL hybrid top cap mod?

No.

1: "sticks out almost as far as my rda does"