I'll try and do a photo tutorial tomorrow for you Kat.Ok, so does one simply unscrew the oil can diffuser film thingie to access it? And if so, then what?
I'll try and do a photo tutorial tomorrow for you Kat.Ok, so does one simply unscrew the oil can diffuser film thingie to access it? And if so, then what?
I'll try and do a photo tutorial tomorrow for you Kat.
I'll try and do a photo tutorial tomorrow for you Kat.
Y'all probably know this already, but I got an email from something I must have submitted for months ago.
It's back in stock.
Siren GTA (MTL) by Digiflavor
Late nights when I can't sleep I end up hunting for sales... did not figure I'd see this one.Good find, Cosmic!!!!!!!!!!!!
I picked up one this time... see what the "hype and the gripe" is all about that I've read soo much about on this forum...Welp, late nites are good nites, in my least humble opinion.![]()
Fab find, dear one. I'm sure you just made a LOT of people happy.
Just wish I was one of them! (I'm still "iffy" about the Digi, and don't really need another.)
Hinting about running for tinkerers union president ? I'll cast my ballot for ya 52.I would think that the best way to explain just what the Digiflavor Siren is, is that it is a "Tinkerers" MTL RTA, meaning, a MTL RTA that needs (in most cases) some "Tinkering" done to it before it performs as good as you would like, and expect. A few have received a "Tinker Free" Siren that performs Brilliantly right out of the box, but most have to "Tinker" a bit to get theirs up and running to their satisfaction. I have a 25mm and a 22mm that I have had to put o-rings in to get it to perform without seeping e-liquid thru the bottom air adjustment ring (the ring on the bottom that you adjust your air intake). The Factory did not tighten the Center air hole tube enough and that has caused juice seepage out of the air adjustment ring on the bottom of the Siren. That's what all the fuss is about @Cosmic_Glaze. Some like to Tinker, and some don't. As with all things vape related, it's NEVER Perfect for all, or most, but a lot of us here LIKE to "Tinker". As a matter of fact, we should look into a "Tinkerers" Union, if for no other reason than to maybe put together a "Tinkerers" News Letter......oh wait, that's what this Forum Thread is all about isn't it ?? My Bad !!![]()
I picked up one this time... see what the "hype and the gripe" is all about that I've read soo much about on this forum...
On the ground laughing, that's why I clean my Sirens in a big colander in the sink.Good luck, CG, and let us know...
One thing worth noting (in addition to The Tinkering Tales throughout this thread).
There is an O-ring that will either be stuck to the bottom of the glass, or down inside the base (when you take it apart). Be VERY careful with this ring. It's rogue, and always looking to escape. Never forget about it, any time you disassemble the tank. It's very sneaky, and appears to be quite smart too. If you don't remain cognizant of these facts, it will escape one day.
In fact, I believe that a fair number have already escaped, many via drain pipes in homes all over the land. I envision a yacht where they've all met, and are having a HUGE party, celebrating their freedom. The yacht is almost certainly named, "Lord of the Rings".
Watch that ring!!!![]()
Oh so tempting. Just wish they had it in black foe the 22mm
On the ground laughing, that's why I clean my Sirens in a big colander in the sink.![]()