Well the Reuleaux showed up today and so far so good. Had a pretty easy time getting everything set up with escribe and I'm attempting the screen ribbon fix tomorrow.
I just have a couple questions.
1. Does anyone have a .csv file for 3 LG Hg2s for the battery section? Also the only three options in the drop down are LiPo, LiFePO4, and power supply and nothing for Li-Ion.
2. I was going to run battery analyzer but it says "attach a resistor capable of sinking the test power you choose" and I've got no clue what that means. It also says it will fire the battery until empty. Does that mean its going to fire it constantly from fully charged to fully discharged? None of that really makes sense to me hence just asking for a .csv file to upload for it. I'm sure something is wrong with the battery settings. I'm already reading half a battery after only a couple hours of use.
or is there some easier way to do this. Currently its set on LiPo, 9wh, 3 cell, 3.09v soft cutoff
3. How much fluctuation is there supposed to be when running Atomizer Analyzer?
4. What is the difference in maximize puffs and maximize recharges?
5. I read that you now change it to where temp is where wattage is and wattage is where temp is but I can't figure out how to do that any ideas?
6. Does the Reuleaux DNA200 version have the same 510 issue as the RX200? I've always used a heat sink on all my devices but I want to make sure its not going to mess up TC readings. I'm also concerned about how much heat my RDA is producing and releasing into the mod and would like to use the heat sink if possible.
Still, I'm loving this thing so far and have had a pretty good time playing around with escribe. It was confusing at first but I think I've got the hang of most of it. Now if I can only bring myself to take the device apart and fix that screen ribbon.
