I Have a provari and a kayfun, I have been using it for a while and made a new coul for it a week ago and check it and it was at 1.3ohms, it worked fine for a few days then i notived the vape getting extremely weak, so I checked my ohms on the provari and it says its 3.6 ohms? Then i check it again and it says 2.7? when im checking it its always changing and going down during the check on my provari. So whats going on here? Is it safe to vape?
Do I have a short or something?
- Thread starter Timeghoul1
- Start date
- th_trl_thread_readers 0
- Status
Most likely you have a screw loose 
No, seriously, make sure the screws holding the coil in place are nice and secure.
No, seriously, make sure the screws holding the coil in place are nice and secure.
that happend to me recently too. i had a screw loose and resistance was jumping around.try not to vape with it like that it could damage your kayfun. try and fix it immediately. when i lifted the microcoil before i clipped the ends i must have loosend it a bit. i always make sure to re tighten before assembling.
It can damage my kayfun? how? i only ask because im about to go do an 8 hour shift and i dont have enough time to tear it apart right now and i need my vape
If the coil is loose it could short inside your kayfun. While the provari has short protection and won't fire if it detects a short, I'm not sure what it would do if you were firing your mod and it shorted while you had the button pressed. Do you have any other tanks/atomizers to take with you?
I have some old kanger tanks but they are really bad i mostly just use my kayfun nowadays.
Right now it's a loose connection with jumping resistance, but it has the potential to short. Your call.
Most likely the screw everyone above mentioned, but if it isnt... check to see that the 510 connections are adjusted for a perfect tight fit.
- Status
Similar threads
