E Juice Mixer
- Thread starter Wraith504
- Start date
- th_trl_thread_readers 0
- Status
I think the Centrifugal force created will make it so not much mixing is happening.
BTW alcohol will evaporate at room temp so no need to heat it up, probably doing more harm to your juice at that temp anyway, I would imagine. And unless you have the cap off no alcohol will evaporate. Not sure if you were thinking of heating it while you "mixed" it or not.
BTW alcohol will evaporate at room temp so no need to heat it up, probably doing more harm to your juice at that temp anyway, I would imagine. And unless you have the cap off no alcohol will evaporate. Not sure if you were thinking of heating it while you "mixed" it or not.
I believe nicotine starts to degrade over 150 degrees which is considered bad for the juice. For steeping you shouldnt go over that temp. Don't quote me on that though. You can find more info on what I'm talking about in the Diy section of this forum. Search for speed steeping or steeping with heat. Something like that. I hope this helps. Good luck!
I have used heat in various forms for quick steeping. Hot tap water, Water from k cup coffee makers, outside temp/humidity. etc.
The angle of the bottles i think would help combat the force. I can definitely see that its being mixed when i stop it, there is all kinds of nasty bubbles/foam rising to the top.
Shake the bottle vigorously and remove the cap. Place the open bottle in a warm, dry room away from sunlight for a few hours (maybe 4). The warmer the room and amount of alcohol will determine the time needed. This method is subjective to reach your ideal mix and is the process that I use when I find alcohol present. Replace the cap and shake again. Repeat as necessary. Good luck.
This is how I mix my juice. Easy to make just file down the end of the clamp to fit in your jig saw.
It never ceases to amaze me how often people come up with these unique mad scientist ways of making there juices. This is one of the reasons why this forum is never boring
Yea, I bring the bottles with me to work, vice the drill Tape the bottles to a close hanger inserted in the chuck. Then tie strap the trigger to a certain med/slow speed. Then I just let her run for a few hours, remove the caps n let them sit.
There all interesting methods and reasonably safe as long as your careful with power tools. I prefer the more common methods of mixing my base and flavoring using cylinders and syringes to measure then shaking and vaping and if nessessary steeping in warm water using an ultrasonic cleaner. The one that scares me the most are the people that steep in a microwave. I've already herd of several people getting scalded by a super heated mix as well as bottles bursting. So if your going to get creative please think it through carefully. In my opinion the safer method is always the better method.
Last edited:
Im a mechanic I use air and power tools all day, So I have that safety aspect covered. Im not a fan of a microwave method at all. I usually just hot water bath and shake by hand. But I was bored with a slow time at work and just through this together.
- Status
