Easier draw, more vapor, more flavor - easy mod!

[edisme518123]

So... I decided to see what effect I would get if I drilled the hole in the mouthpiece slightly bigger. To do this I simply stuck a small paper clip into the hole of the mouthpiece and pulled the endcap off. I then used a 5/64 drill bit to carefully bore out the hole. Here are the results:

Left: Newly bored hole Right: Standard hole

The draw is just a tad easier but produces much more vapor with less effort. The flavor is also much more evident since the vapor passes past your taste buds much more slowly. All in all this was a very easy mod and took me less than 2 minutes to complete, test, and take pictures. So, if you're after easier draw, more vapor, and more flavor... this might be for you.

 

[phylo]

You can actually remove the piece with the hole in it for the same result. Just take a paper clip or something else and stick it in the hole and use it to pry the little piece out... Or you can gently bite down on the sides that are not flattened and it will just pop out.

Phil

 

[gordo]

It does seem to make a difference.

 

[notsmellyanymore]

Hmm... used a Bradawl to make the hole bigger on my 901, didn't make any noticeble difference. Stuck it on the Trogg-Screwdriver - that worked

Widened the hole on a Kissbox cart using a very small electritions screwdriver and that did make a big difference.

 

[edisme518123]

You can actually remove the piece with the hole in it for the same result. Just take a paper clip or something else and stick it in the hole and use it to pry the little piece out... Or you can gently bite down on the sides that are not flattened and it will just pop out.

Phil

I found that doing this actually made the draw too easy and inhibited vapor production. By just drilling the hole bigger you make the draw just easy enough in my opinion.

 

[tribalmasters]

No modding needed! Bite down on your cart and the end piece shoots off easily