eGo CLR Ti Rebuild. Do these numbers look right?

[indypilotcfi]

I'm playing with Steam Engine to figure out how I'm going to rebuild my eGo CLR Ti's to 0.5ohm like from factory.

Coil wrapping
The setting I used were:
Titanium 1
26 AWG (Joytech says they use 0.4mm)
Single Coil
0.5ohm
2.5mm Diameter Coil
5mm Total Length

It says I need 12.68 wraps. That sounds like a lot to me. Is that right? Did I do something wrong?

 

[SLIPPY_EEL]

That is the same result as i get when i input your specs to steam-engine

 

[indypilotcfi]

Hmm, maybe I need to consider 28AWG. 13 full wraps seems a bit much for a CLR head.

 

[TheRussianVaper]

I would strongly recommend a cheap ohm reader, you can plug the tank with the new rebuild coil into the reader to see the ohms.