Dieseler- That sounds feasible but doing it hand may be an issue. I think the bit will dance prior to starting the hole and destroy the finish. Best to find a friend with a drill press to keep it clean and precise. Keep us posted please. While we are speaking of tinkering with the Mega V2's- I am fairly new to the Ego one tanks and still trying to find the right diameter of coil and correct wicking for a leak proof system. (not sure it's possible) One thing I have been doing to alleviate fluid coming through the air passages is to place a very small amount of cotton in the bottom section prior to screwing on the coil. Very small pieces do not seem to hamper the air flow and it sure sucks up the extra fluid. So far this is keeping my hand/fingers dry.Just make sure you don't cover the positive post and your good.
pufZeppelin - sounds like you have been there done that- scratch that idea- THX
One thing I have been doing to alleviate fluid coming through the air passages is to place a very small amount of cotton in the bottom section prior to screwing on the coil.
I think this is a good idea and I have been doing that on the ECR's also. Every once in a while for reasons unknown just about every tank I own has let go of its juice. So I thought 'oh time to recoil and rewick', but that has not always been the case since on the one I just did 2 days ago just let go of its juice. So this time I changed the type of cotton I use. Normally, I have been using 'rayon' but had some cotton bacon I had not tried so here goes. Will see if there is any improvement......
Thanks for posting.
