There was a limit of 10 when I ordered this afternoon. Only ordered 4.
Tried to save a few for y'all![]()
Interesting. I was limited to 5 by the time I ordered.
There was a limit of 10 when I ordered this afternoon. Only ordered 4.
Tried to save a few for y'all![]()
Interesting. I was limited to 5 by the time I ordered.
I son't mind the draw on them. It is a little tight, but the vapor it produces it perfect for it. I am going to crack one open, and see ways to mod it though. I just have to wait on getting more first.![]()
the problem is its different on every battery, i had one battery that was decent, then others it was like sucking through a straw where someone was covering the end. usually I could twist it slightly so that it would draw better, but then it can get loose and twist on its own.
someone did fix it, but the only way it seems to fix it is to slot the inner section, no easy task unless you have a dremel I suppose and a bit that will let you slot it without messing anything else up.
Well, if one is so inclined to mod the airflow for certain PV's, then the best time to do it would be during a rebuild since the center post gets pulled out of the shell.
Remember, the center post slides into the shell into silicone gaskets. There is some tolerance for adjustment here to pull the center pin down a little so the positive battery post need not make a air seal by pushing up into the inner section.
I would think that this could be done without removing the coil, but there would be some risk of breaking the wire if it has been used and has become brittle.
So first pull tank the tank off, pull the center post out 1-2 mm, screw the assembly on the battery just until the center post makes contact, then put the tank back on and seat it against the battery.
The tight draw is very easily fixed by using a couple of 510 to 510 adaptors. Using those adaptors instead of the 510 to ego adaptor opens up the draw to about the same as a CE-2. It makes a massive difference to the draw.
That works as I don't have access to computer or able to use the phone during work hours.We should have the lower ohm Stardust in very soon, hopefully within a week.
Next time we release we will try to release in the very early evening when people are gettign home from work so that if anyone is still at work they can have a better chance at gettign some.
Bad, have my Stardusts shipped yet? I ask this because I have yet to receive a shipping notice.
I am the guy that ordered and paid for them more than six weeks ago but only got a note on the invoice that due to inventory problems you could not send them now and that mine would be sent when they were restocked, in about two weeks. We all know that the restock was more like six. And I patiently waited.
Then on Tuesday I saw this thread but they were sold out before I could order additional (or verify that my original three had been sent), so I posted in this thread. I received a PM around 1 AM on Wednesday that it would be taken care of that day.
So, have mine shipped yet? If not, I believe that the correct thing to do would be to overnight it to me; given that I have been patiently waiting for over six weeks, why should I have to wait an additional hour, let alone day(s)? Mine should have been sent first thing when they arrived (on Tuesday), even before counting and putting them up on the site. Okay, it appears that I had been forgotten. This would be the second screw up on Gotvapes end. So then it should have shipped first thing Wednesday. I do not believe it would be equitable for my order to have to wait to see if there are extras available after fullfiling the new orders.
I have been a regular customer of Gotvapes for a long time and have been quite satisfied until now. I do not believe that I am being unreasonable here. I just want what I ordered and paid for. And in a reasonable time.
Sent from an alternate reality using my Droid