Already being discussed in the istick thread.
I completely agree except i wish they would bump the amp limit a bit. From what i've read, it's limited to around 3.2amps?I'd like to see the pin move slightly so a 22mm atty will fit flush with the device, but needs to be adjustable. I don't really like the chrome on top and bottom. Charging port is fine where it is for me. 20w is also fine.
Was keeping up with that thread on Reddit, so many people want so many different changes, that if eleaf did everything everyone wanted, it would be way more expensive and way bigger.
Looks like they're working on the Eleaf iStick version 2.0 already and you can submit your suggestions/ideas on improvements here. Also, am i the only one that didn't know that iSmoka is owned by Joytech?
![]()
The biggie for me is to stop using MEANS and use RMS.
Floating 510 pin
Bump it to 30 watts
User changible battery
Had the i stick been 30 watt and fully regulated I would have bought 3
As it is 20 watts is not quite enough for some of my rba dual coil builds
and when I dont want to carry an rba I use a clearo that would burn on a fully charged stick
so fully regulated and 30 watt for me please
Have you guys seen this....................Mini iStick
What kind of clearo would burn on the lowest setting? Are you saying you can't regulate the volts/watts on a fully charged istick vs. an istick with a more discharged battery?
I'm aware that it's putting out more power than desired, but on my 1.9 ohm naughty mini it's showing 3 volts/4.7w. Lets say it's actually 4 volts. An ego c can output that and not burn clearos. Please explain.
best regards, larry mac