EVIC with kanger pro tank Troubleshooting.

[Matt Sanfratello]

Ok I'm new here but, I've had this ecig for maybe 2 months if that and for some reason it just does not hit hard anymore at all. I have the voltage at 5.0 and i get a lot of smoke but it just doesn't hit that hard. My small torpedo V2 Still hits hard like a champ and i actually get LESS smoke from the torpedo and it hits HARD, rather than the EVIC giving me a lot of smoke but not hitting really soft. any help here?

Could it be the liquids? atomizer? tank? thanks!

 

[Matt Sanfratello]

It's just really annoying you know what i mean? when your just hitting and hitting and there is no power to the hit its just like smoking air.... i like the harsh hit to my throat. And it used to do that very well. Now it's like terrible.

 

[nobreak1970]

Same juice?

 

[Matt Sanfratello]

ive been using different juices but the same juices hit hard in the other ECIG

 

[Ipster]

How old is the coil? they're replaceable.

 

[djsanchez]

On the Kanger Protank II, the Protank mini's , MT3's and the T3's you'll find this needs cleaned more ofter then a top wick system. When my protank II seems clogged what I do is..

1.) Take out the coil/wick by unscrewing.
2.) Pop off the rubber gromit (don't lose it)
3.) Firmly pull the "Rod" on the top (wiggle it a bit) and it will pop out.
4.) Now you'll see the little ("flavor wick") remove it (it's sitting on top)
5.) now you'll see your dirty coil and wick. screw that on to your battery
6.) turn it on and press the power button (looking inside at the coils)
7.) Only power up for 5 seconds holding the button, then let go turning it off (you'll see and hear it burning off the "Gunk")
8.) Repeat step 7 above until you see your coil and wick nice and clean)
9.) put your "flavor wick" back in
10.) Put the top rod back on
11.) put your rubber gromit back in the rod.
12.) screw it back on your tank.

It should hit like new... Hope this helps

 

[Sthur]

Also if you have the pro tank 2 kit, it comes with the 2.2 coil I think installed. Try switching to the 1.8 coil and should hit better at little lower volts.

When you use the evic check the card that come with the pro tank and stay between the voltage for the best vape.

Here is safe volt chart. Stay in the green.

Safe Vaping Power Chart | Flickr - Photo Sharing!

 

[crxess]

Protanks come with a 2.5ohm coil and yes it is your Tank performance NOT the eVic. If it is pushing clouds, it is Vaporizing the e-liquid.

Have you lowered your Nic levels when re-ordering?
Have you changed flavors drastically? Certain flavors have little hit even at higher nic levels.

Are you comparing POWER or Different delivery systems? i.e. is the other battery powering the same Tank? It it running a Top coil Clearomizer?

Only way the eVic would be involved is if your Battery will no longer supply steady power or your coil ohms has gone way up.

 

[Matt Sanfratello]

Just wanted to let you know your a genius, I didn't take off the rubber garmit and doo all the other stuff. but i just took the flavor off wiped off the wicks and the screwed it into my battery and burned the wick a little bit then i threw my tank back in and it hits good now. Must have been the THICKER liquids from elevated vapor that did that. Im not to sure.