DNA250C Reference Case: http://www.mamumods.com/dna250c/250...
DNA250C Board: http://www.mamumods.com/dna250c/DNA...
DNA250C Board: http://www.mamumods.com/dna250c/DNA...
Its a shame that co-ops arent feasible here anymore.....
The Reference Case is up on SW 
No reseces for the 510
Does a 25mm sit on the Reference mod with out over hang?
Even if it does, with out a recessed 510 any thing bigger than the 510 will show a gap
I have 2 in my cart now, But I'm really disappointed about the no recessed 510 situation
Can the print be adjusted to recese the 510, flush with the top of the mod?
I would hate to have to "mod" the print to recese the 510 my self!
No reseces for the 510 Does a 25mm sit on the Reference mod with out over hang?
Even if it does, with out a recessed 510 any thing bigger than the 510 will show a gap
I have 2 in my cart now, But I'm really disappointed about the no recessed 510 situation
Can the print be adjusted to recese the 510, flush with the top of the mod?
I would hate to have to "mod" the print to recese the 510 my self!
Comments have been passed along, but I think he is asleep right now.The Reference Case is up on SW
Does a 25mm sit on the Reference Mod with out over hang?
Even if it does, with out a recessed 510 any thing bigger than the 510 will show a gap
I have 2 in my cart now, But I'm really disappointed about the no recessed 510 situation
Can the print be adjusted to recese the 510, flush with the top of the mod?
I would hate to have to "mod" the print to recese the 510 my self!
1mm overhang on a Pharoh
Sent from phone, please excuse fat thumbs and autocorrect.
Sent from phone, please excuse fat thumbs and autocorrect.
1mm overhang on a Pharoh
Sent from phone, please excuse fat thumbs and autocorrect.
So I guess the non recessed 510 isn't as big of an issue then.
From your pic it looks like an atty as big as the 510 is going to be the limit any way
One more thing I have noticed is the width of the top of the mod, it looks to thick for a 510 to go thru & be secured with a nut in side the case.
I'm assuming the Reference Mod has an Evolv 510 that is threaded into the case? Similar to the ERM+?
I'm just speculating here, but from the 3D model on SW the top looks to thick!
I was briefly excited, but now with a good look at the Reference Mod, not so much
A mod with these capabilities needs to sit a bigger atty, whats the sense of having all this power & battery if it can only hold a 22 or 23mm max
I'm going to pass on this "Reference Mod" hopefully some one will upload a print that is more to my liking soon.
Similar threads
- Locked
