I finished cleaning my Hotcig GSL parts. I assembled them without o-rings and put them back into the wooden boxes that they came in. I have all the new o-rings for when/if the time ever comes to do something with them.
Friday morning:
Here is a story that is hard to believe. I got out my Vapecig VTbox 200 with the OG TGT4. I'm trying to keep the mods in my bag at storage levels. So I'm thinking this one needs just a little more charge so I can use it a litle bit. So I plug it into my laptop and device monitor says 1 cell is 5.8 volts another is 2.48, ect. I do a reboot and it changes which cell is the high one. I open it up and disconnect/connect the 12 v connector. Now it shows one cell down to .14 volts. I then remove the battery and measure off the JST and all cells are 3.89 volts. Plug it all back together and it works fine. A bad connection or ? at the JST plug.....or rebooted that famous TI chip. Reading over 5 volts sure sounds like the chip. Did I just discover a "fix" ?
You see that once in awhile with those Hotcig DX200 mods too. Disconnect the lipo and then reconnect and all is well again.
Similar threads
- Locked
