feels like something is missing...

[bullet08]

my first set up was penny clone with magma clone. it was ok. i ran that with dual coil at .7 ohm. didn't have dense vapor, but was starting out and it met my need. this week, i took magma off and put tobh clone on. i don't know what that optimal set up was, so i set it to .8 ohm. it felt ok at first, but it seems i want more vapor. i want to fill my lung with dense vapor and want to feel i'm inhaling. it's not the battery or lack of voltage, i charged it yesterday, and it's still at 3.9 volt.

i read on other port that tobh will need lower resistance. so i'm planning to drop it to .4 ohm. i don't want to go too low. my battery is samsung and has CDR at 20 amp. the liquid i'm using is 70/30 pg/vg.

what would help me to produce more dense vapor? different liquid with higher vg? lower resistance? all of them? i'm vaping with all AFC open.

 

[graybuck]

If you want more Vapor then higher VG juice is where you want to go.

 

[bullet08]

thanks, i think i'll start off with 50/50 and see if that feels better.

 

[Kloudz]

What mod are you using?
Higher vg will produce clouds

 

[Sarin]

To be fair the Magma isn't a cloud chasing dripper but the flavour from it is very hard to beat. A plume veil / Tobh or Mephisto will hammer it in the could chasing stakes. Bigger airflow, lower resistance, higher VG is the way to go!

 

[Cool-breeze]

The biggest factor in vapor production is air flow. You mentioned you had the afc open BUT how do those openings relate to your coils? If you turn your holes 45 degrees it will make a deference. For the better or worse is another story. VG does help, and how your coil is built (size, resistance, closeness of wraps etc) also can make a difference. If 20a is your bats limit you can technically build down to .21 on a full bat but I wouldn't chance it. 0.1 ohm is within margin of error for many dmm so I personally wouldn't go below .4

 

[bullet08]

played with build on the tobh clone. now i can get more vapor out of it. it seems low resistance, and placing the coils right next to the air flow intake seems to help a lot. tho, going down to .4 ohm seems to make the vapor rather harsh for me. backed it up to .6 ohm and now it's rather pleasant and gives what i'm looking for.

 

[Smann245]

A tip for helping with harsh TOBH hits - Hit it hard. Really flowing the air through it keeps things cooler and smoother. Of course there is a point where the build is just too hot even for high flow hits.

 

[TheRac25]

The biggest factor in vapor production is air flow. You mentioned you had the afc open BUT how do those openings relate to your coils? If you turn your holes 45 degrees it will make a deference. For the better or worse is another story. VG does help, and how your coil is built (size, resistance, closeness of wraps etc) also can make a difference. If 20a is your bats limit you can technically build down to .21 on a full bat but I wouldn't chance it. 0.1 ohm is within margin of error for many dmm so I personally wouldn't go below .4

0.1 in 0.4 would be +-25% accuracy rating, i haven't seen anything that bad but then again i dont go around buying the 10$ walmart special

 

[TheRac25]

what would help me to produce more dense vapor?

power, airflow and juice composition