Labelled as "510 XL CE2 Clearomizers Ultimate Edition", and it's been in use since approximately March 10. It has been used only for BWB Applewood and just under 40 mL of it. I haven't taken it apart yet but it is definitely NF. Typical use at 3.7 V although occasionally I did bump it up to 4 for curiosity's sake. The package said 2.4-2.6 Ohm but over the last few weeks its been testing at about 3 ohm. How does this compare to everyone elses luck? Cheers, VC
Finally had my first CE2 burn out
- Thread starter VitoCorleone
- Start date
- th_trl_thread_readers 0
- Status
As you said, it depends on e-liquid and voltage a good bit.
I change flavors often, therefore I clean & dry burn often and I still get 2-3 weeks out of each.
Not bad for being disposable
There is also a clearomizer section now...here.
Edit: Did you measure the resistance of your leads? My resistance usually decreases with use.
I change flavors often, therefore I clean & dry burn often and I still get 2-3 weeks out of each.
Not bad for being disposable
There is also a clearomizer section now...here.
Edit: Did you measure the resistance of your leads? My resistance usually decreases with use.
Last edited:
Ah so there is! mods please move at your convenience. I agree that for $2 its not a bad piece of equipment. I was taking into account the resistance of the leads (.4 Ohms, cheap kit) but some variation is always expected. Thank you for your input Skelley!
No problem, thanks for posting your CE2 info 
I've been enjoying the CE3's more and more lately. My CE2's have been getting cleaned and stored away for a rainy day.
I've been enjoying the CE3's more and more lately. My CE2's have been getting cleaned and stored away for a rainy day.
- Status
Similar threads
- Locked
