Finally ordered some mechs, RDA etc

[Acheron44]

I didn't see those graphs, but I had a look at the coil wrapping calculator.

So ideally I gotta use lower ga kanthal, wrapped around a much smaller diameter rod. I was wondering how you'd get 12 wraps - It wouldn't fit on the deck otherwise [emoji13]




Sent from my iPhone using Tapatalk

 

[USMCotaku]

You can use 30....though I like 28 gauge for most things. Definitely use smaller diameter wraps....you can then use more wraps, getting the same ohms....giving you more surface area on your coil...better vape produced

 

[Acheron44]

Ah, that makes perfect sense!


Sent from my iPhone using Tapatalk

 

[USMCotaku]

Lol...quick edit....said thongs instead of things

 

[regal55]

Do you notice a smoother vape do to no PWM at 35 kHz? Its the first thig a I noticed when I bought a nemy clone. I like to use with the small battery, very reminiscent of smoking a cigar.

 

[USMCotaku]

I got away from low htz pwm batteries before I jumped into mechs....i had been using an itaste vv v3, which scopes very smooth, similar to provari.

 

[HecticEnergy]

I didn't see those graphs, but I had a look at the coil wrapping calculator.

So ideally I gotta use lower ga kanthal, wrapped around a much smaller diameter rod. I was wondering how you'd get 12 wraps - It wouldn't fit on the deck otherwise [emoji13]




Sent from my iPhone using Tapatalk

Charts were from different websites.

You should be able to use the 30ga you got just fine. Just need more wraps on a smaller rod.
It's harder to thead the cotton through with smaller diameter builds, but it can be done. I definitely use 28ga more than anything.

 

[Acheron44]

Ok good to know. I'll order some 28ga next order too [emoji106]


Sent from my iPhone using Tapatalk

 

[HecticEnergy]

Any attempts today?