Ok so here I am with a working wick and coil. I finally am able to make a coil good. Ithe previous wicks I made before wicked so well but this last wick I made sucked balls. Wouldnt wick. Had to find one of my wicks I made previous and recoiled and bam... big freaking clouds and have flavor.
I lost one of the screws to my agat2 on the far side of the negative post for silica. Went to menards and after looking like an idiot for 10min I got help and found the righr screws which is 2mm. Now.. it fits... but the screw head is a tad wider than the one that was on the agat2. It screwed down all the way but had to kind of give it some force. Not a lot but more than the original.
I also picked up 2mm washers.. ehh.. to small. Wanted something smaller than the 3mm washer I bought the first time and didn't see anything smaller... but found 2mm and 2.5mm washers after help finding the screw.. also will not all are ss. Will try the 2.5mm washer after this setup takes a pooper.
So now I am comfortable and able to make coils. My first problem was top hot leg on positive post. Fixed that with the washer. Then after that I would get hot spots. I always.. emphasize always.. had maybe a mm gap on each coil other than the top and very bottom coil. I finally after a full week of making coils and really getting frustrated and ...... to the point yesterday I gave up completely.
Today Iafter work I said one more try and bam!! Perfect coil but a wick that sucked. Now I need to work on the wicks because I made 3 today and boy did they suck at wicking anything even with screw out. So I grabbed my first wick and rewrapped another nervous on making another. Ill say its the best vap so far on this rba I had. No hot spots, metallic taste so I'm a very happy rba vaper right now and want to thank everyone on this forum and youtube. Sorry if this is long but had to let you guys know.
Its 2.0ohm at 4.4v
I lost one of the screws to my agat2 on the far side of the negative post for silica. Went to menards and after looking like an idiot for 10min I got help and found the righr screws which is 2mm. Now.. it fits... but the screw head is a tad wider than the one that was on the agat2. It screwed down all the way but had to kind of give it some force. Not a lot but more than the original.
I also picked up 2mm washers.. ehh.. to small. Wanted something smaller than the 3mm washer I bought the first time and didn't see anything smaller... but found 2mm and 2.5mm washers after help finding the screw.. also will not all are ss. Will try the 2.5mm washer after this setup takes a pooper.
So now I am comfortable and able to make coils. My first problem was top hot leg on positive post. Fixed that with the washer. Then after that I would get hot spots. I always.. emphasize always.. had maybe a mm gap on each coil other than the top and very bottom coil. I finally after a full week of making coils and really getting frustrated and ...... to the point yesterday I gave up completely.
Today Iafter work I said one more try and bam!! Perfect coil but a wick that sucked. Now I need to work on the wicks because I made 3 today and boy did they suck at wicking anything even with screw out. So I grabbed my first wick and rewrapped another nervous on making another. Ill say its the best vap so far on this rba I had. No hot spots, metallic taste so I'm a very happy rba vaper right now and want to thank everyone on this forum and youtube. Sorry if this is long but had to let you guys know.
Its 2.0ohm at 4.4v
Last edited:
