First Build

Status
Not open for further replies.

officer196

Senior Member
ECF Veteran
Verified Member
Nov 26, 2014
160
206
Ft. Worth, TX
Well a couple weeks ago I posted about my debate into getting into rebuilding, specifically rda's. I'm happy to say I bought my first rda (dark horse) and completed my first build.

In all honesty it was fairly easy. Used 24g kanthal, 7 wraps, dual coil, ended up at .4 ohms and wow what a taste. It was a cool experience and my local vape shop even walked me through the build to ensure it was done correctly and safely.

I walked out with building supplies and a ohm meter.
 

officer196

Senior Member
ECF Veteran
Verified Member
Nov 26, 2014
160
206
Ft. Worth, TX
Woo-Hoo!! I have a larger computer desk and I use it to build/maintain. Because I am conscious of spilling e-juice out of a RDA, I only use them with my mech there. Right now it is Red headed .... from Good life and Blueberry from Hoosiers. TV for football is viewable, too.

It is my spot.

I'm jealous brother, still working on clearing out a spot. I ended up using the kitchen table when I did my own solo build
 

officer196

Senior Member
ECF Veteran
Verified Member
Nov 26, 2014
160
206
Ft. Worth, TX
Congrats. :) You're one step ahead of me, I've got all my stuff including Ohms meter on order so I'm looking forward to doing the same very soon. :)

Promise, it wasn't bad, obviously it still commands respect, but it was fairly easy and straight forward. Wish ya luck when you get your supplies.
 

edyle

ECF Guru
ECF Veteran
Verified Member
Oct 23, 2013
14,199
7,195
Port-of-Spain, Trinidad & Tobago
I used to rebuild my protank heads, and a few weeks ago I finally got 2 rda's and some rta's and I'm still running single coils.
I guess I did try to do a dual coil, but quite frankly it's too much trouble unless I get a deck where I don't have to try to get two coils to share the same hole/screw on the positive side.
 
Status
Not open for further replies.

Users who are viewing this thread