First time diy, seems a bit harsh.

[crazywesc]

This is my first time at diy and the first two recipes I made has to much throat hit on a dripper. It's not to bad on a kayfun but if I use a sub ohm rda I get a really harsh hit that makes me cough.
First recipe was juicy peach 5%, mango 5%, pineapple 3%
Second was watermelon 9%, kiwi 7%
Both were mixed at 6mg nic and 65% VG. All flavors were TFA.

I have always vaped premixed juices from 50/50 to 30/70 PG/VG in my dripper and never had a problem with that harsh of a hit. So what am I missing here?


Sent from my iPhone using Tapatalk

 

[boomerdude]

Go with a higher resistance coil or stick with the Kayfun. It sounds like a heat problem. Maybe even a long drip tip may help.

 

[clh2121]

I'm guessing TFA Pineapple and Kiwi? I know the pineapple (and assume the kiwi) has a harsh throat hit. It may be the combo of pineapple and mango too... The one I make that's like that is strawberry, pineapple, and mango and it only goes into tanks because it's harsh.

 

[dannyv45]

With the dripper use lots of wick and get the voltage as low as it will go.

 

[crazywesc]

I use a mech so I can't adjust the voltage. I really don't want to change my mods because it has always worked well with pre mixed juice.

I'll make some more juice tomorrow without the pineapple or kiwi and report back.




Sent from my iPhone using Tapatalk

 

[UserDave]

Might be the vg if the maximum you tried was 50/50. For me going from 20/80 pg/vg to 40/60 made me cough at first and i needed a little less voltage.

 

[Big_Jim]

Are you sure you're mixing the nic down to 6mg? Have you tried vaping your PG/VG straight? I'd suggest doing that first to see if either of them could be the culprit, and then pick up a nic test kit to see if your final calculations are correct at 6mg.