Fix for not squishing the center post washer on a vamo with a 510 to ego adaptor.
Items needed:
1. piece of harder rubber cut 7/8" round with a 1/4" hole in middle. You need it to give a little bit.
2. 1- tank Air Flow Controller.
3. 510 to ego adaptor.
4. File
5. ego type clearamizer of your choice
How:
1. Screw air controller, and 510 to ego together tight, so center pin is pushed down as far it can.
2. Then put the rubber washer on the air controller,
3. Screw on the clearamizer so it doesn't wobble .
4. Screw it on the Vamo lightly till you get a Ohm reading. look at the gap between the top of Vamo.
5. File off the center pin a little then re check Ohms, File re check, you want the gap to be tight , and get a good Olm reading, then give it a little bit more tighting so it won't screw off with the clearamizer.This is what I did and it works great. Made it about 1" taller, But no messing up center washer
Items needed:
1. piece of harder rubber cut 7/8" round with a 1/4" hole in middle. You need it to give a little bit.
2. 1- tank Air Flow Controller.
3. 510 to ego adaptor.
4. File
5. ego type clearamizer of your choice
How:
1. Screw air controller, and 510 to ego together tight, so center pin is pushed down as far it can.
2. Then put the rubber washer on the air controller,
3. Screw on the clearamizer so it doesn't wobble .
4. Screw it on the Vamo lightly till you get a Ohm reading. look at the gap between the top of Vamo.
5. File off the center pin a little then re check Ohms, File re check, you want the gap to be tight , and get a good Olm reading, then give it a little bit more tighting so it won't screw off with the clearamizer.This is what I did and it works great. Made it about 1" taller, But no messing up center washer
