Hi guys, i have a question... i have the 2.0 ohms 510 atty from happy vaper, and i had it on the provari and i guess kinda tightened too much, i figured that because when i put it on the ego-t 650 mah battery and screwed it in all the way and it wasn't making a connection. so i decided to lower the bottom of the atty by using a paperclip and pulling the bottom out a little bit. well it did work by making a connection but, it lost a lot of flavour for some reason and i thought it was because of the ego battery not being powerful enough so i put it on the provari at 4.2 volts (thats what i was vaping at before and always) and surprisingly the flavour still wasn't as strong, a lot of vapour but not much flavour.
so i decided to clean it, since it hadn't been about 3 weeks if not a little more. so i blew inside the atty blowing out all the excess juice. then i ran some hot water through it and did a dry burn because i used a decent amount of dark juices 50-50 ratio pg-vg. so it took a while to get the glow going. then i cooled down by letting it sit in front an a.c for like 5 mins and then ran some warm water through it, then cleared the rest of the water by blowing in it and then letting it dry off for 24 hours. & now i put some fresh juice in it and did some dripping and vaping for like 30 mins and still not much flavour, and now i have been vaping on it more than couple hours and still no improvement on the flavour.
sorry you guys have to read so much and i really appreciate it in advance to whoever takes the time read it and advise as to what happened.
imo i think when i moved the bottom part to have a connection with the ego battery thats where it went wrong.. i tried pushing it back in but still no luck!
again sorry for the long post and thanks again for reading and replying if you guys have any advice!
sorry if its in the wrong section, please move it if it is
so i decided to clean it, since it hadn't been about 3 weeks if not a little more. so i blew inside the atty blowing out all the excess juice. then i ran some hot water through it and did a dry burn because i used a decent amount of dark juices 50-50 ratio pg-vg. so it took a while to get the glow going. then i cooled down by letting it sit in front an a.c for like 5 mins and then ran some warm water through it, then cleared the rest of the water by blowing in it and then letting it dry off for 24 hours. & now i put some fresh juice in it and did some dripping and vaping for like 30 mins and still not much flavour, and now i have been vaping on it more than couple hours and still no improvement on the flavour.
sorry you guys have to read so much and i really appreciate it in advance to whoever takes the time read it and advise as to what happened.
imo i think when i moved the bottom part to have a connection with the ego battery thats where it went wrong.. i tried pushing it back in but still no luck!
again sorry for the long post and thanks again for reading and replying if you guys have any advice!
sorry if its in the wrong section, please move it if it is
Last edited:
