Status
Not open for further replies.

Joshuasculptor

Senior Member
ECF Veteran
Verified Member
Looks pretty easy to make thinking supplies would be old printer for motors(old battery power screw driver would be perfect) battery box and a small piece of tubing that fits motor shaft 2 set screw and a guitar pick.

Or an old remote control car and you could remotely mix your juice. ;)

Ok, this video is super rough. :p
I didn't edit anything.
I just wanted to throw one of the mixers together using an old printer like I mentioned.
If and when I make a new one, I plan to make the next one a bit prettier. For now this will get the job done.
This was just to get the idea out there. :vapor:
Homemade E Juice Blender - YouTube
 

eikon

slave to the comma
ECF Veteran
Verified Member
Ok, this video is super rough. :p
I didn't edit anything.
I just wanted to throw one of the mixers together using an old printer like I mentioned.
If and when I make a new one, I plan to make the next one a bit prettier. For now this will get the job done.
This was just to get the idea out there. :vapor:
Homemade E Juice Blender - YouTube

very cool.
i just put together a magnetic stir plate, alot less work ;)
Build Your Own Stir Plate
you can get stir rods from ebay, or your local homebrew shop should have them.

also testing it against the ultrasonic cleaner for speed steeping...
 

Sdh

ECF Guru
ECF Veteran
Aug 31, 2010
10,509
17,194
U.S.

unloaded

Ultra Member
ECF Veteran
Verified Member
Jun 2, 2011
2,491
2,365
SW. Indiana
Anybody tried Hangsen USA Mix and didn't care for it? I bought a bottle of premixed for my wife, she only likes PinkSpot USA Blend and I can't get it less than 6mg and she's ready to step down again. She really likes the Hangsen and wants me to make her some up. The problem is I'm gunshy with all these sites, just had my debit card hijacked and don't want to go through that again. If you have some you won't use I'd love to take it off your hands. Got lots of flavors to swap, just shoot me a PM.
 

Shilo

Vaping Master
ECF Veteran
Verified Member
Sep 27, 2011
3,717
3,865
Here & There
At what % are ya'll mixing FW flavors at??

It varies Fran some of the flavors are pretty strong like caramel candy I use a very low percent and love it that way---under 5% for sure same for butterscotch. It really depends on the flavor but for my higher PG vaping most fall into 2%-15%. Those that like high flavor and are using a stand alone type flavor I've heard them going up to 30% which is way too much for me.
 

Shilo

Vaping Master
ECF Veteran
Verified Member
Sep 27, 2011
3,717
3,865
Here & There
Thanks much. Right now this is my first shot at FW flavors. I have Teaberry,Chai Tea,Blackberry and Blackberry Brandy.

I think you could safely start the teas at 10-15% and go from there. Fruit I have no idea--never had their fruit. I finally got around to mixing up a couple of those combo ones yesterday I bought from diyjuice.com Smores and Caramel Mochacino I think it is so we might be sampling about the same time.
 
Status
Not open for further replies.

Users who are viewing this thread