Aww Haku, look at you being all colorful and creative
So nice hun
The SX300 chip does not step down below actual battery voltage.
thank you, and thank you!
you know you are my inspiration, i'd never had got a camera to take porn pics, except for doa/warranty issues
What do you think of the bell cap? They're different looking, I'll give them that. But with the need for a nano chimney and the corresponding nano capacity I've been on the fence about getting one since they first appeared.
I'd be curious to know exactly which of the crop of newer 30W devices had step down voltage, not just the yihi. That's my only complaint with the Zero I have, one of the first batch focalecig offered 30W and physical +/- buttons, otherwise I love the device. And the new acrylic blue that focalecig has is very nice looking.
i'm liking the belly caps. as you say, it's a different looking, and renewing is always refreshing.
i don't mind about the small capacity, because i use to have some filled setups and flavors at once: it lasts enough, then. so my problem is just the opposite: liquid degradation in full filled large tanks. it gets filled quickly, no issues (bottom filled though); i use a needle bottle/syringe, but guess a thin tip would also work.
my juices are 99% tobacco flavors, so there is no danger of tank cracking.
am using the kfl v2 nano chimney now, but other spare short chimneys ($1.74) also work ok. i didn't have to replace the o-ring; it seals these chimneys ok, but you have to use a long (16mm) chimney base (if you only have 14mm ones, you can buy a long one, or use a thick o-ring between base and chimney).
step down voltage is important for people who use low wattage. i always look at that detail (for myself, till i got the sxmini: now am using thicker wire and vaping from 12 to 25w; or for suggesting gear to my friends now). yesterday, a friend reported she got her lips burnt, while using an istick with her new subtank nano (1.2ohm coil), and she didn't know why; she was thinking to get rid of the subtank. suggested her to get rid of the istick, lol.
anyway, step down voltage is desirable for all kind of vapers, because you can be sure of the wattage being released. for instance, if you like to vape at 25w on a 0.5ohm coil, a full battery (~4.15v) will deliver near 35w (4.15 x 4.15 / 0.5); 10w difference.
none of istick, kamry 20, smok xpro can step down. other than yihi, you only have step down in mods with dna40 chipset. don't know about the itaste mvp 3 (although MTM thinks it can step down, i doubt it).
i'm suggesting all my friends who need step down, to get the ipv mini: yihi sx130, 30w, can step down in pwm mode (you can select from 2 modes: dc and pwm); floating (spring loaded) 510, affordable price. i've already ordered 2 for them.
it's not sure that the new ipv mini 2 will have step down; it comes with yihi sx330. only version 3 of this chip (100w) has step down. maybe it comes with a variation of the sx330. don't know.
Haku, i like that drip tip that you've got on the aqua!
@ bsop, I think the mvp3 does step down.
thank you!
it suggested me to choose the pencils theme of the photo, lol.
it's the top part of a 2 pieces drip tip from ft (bullet drip tip, you also have it in copper and brass colors), wide bottom bore in both pieces.
came with translucent o-rings, which is fine for clear belly caps
Guess I better head on over there then.
What was going on before this happened? Were you in the middle of vaping? Or was it off and then went to use it and got this?
Hun these questions were addressed to you ...
