Fogger V3 on VV/VW mod?

[jeremyshay]

sorry if this is a super noobish question, but while i assume this is possible, i would like to know how. obviously, no sub ohm vaping, but does anyone have any suggestions for setup? Will it taste as good? Would i have issues with leaking? Im not disappointed in my clearomizers, but i know i can do better, and it will be a while before my kraken and caravela clones get here.
THANKS!!!!

 

[Munnin]

As long as you build it over 1 0hm, a lot of vv/VW devices will fire it at 1 ohm, as long as there is not short in your build where the ApV will let you know if there is. However, you might want to get some 30/32g wire to get a higher resistance since most regulated APVs have low amp limit allowances, so it won't fire to high anyway depending on your needs if at. 1-1.8 h load, using 28g you need to many wraps to get to 2 ohms. However, it will work fine with right build and taste is dependent on build, not mod.make a 2 him coil with 32g kanthal and your golden.

 

[Munnin]

Not a fan typing from an ipad, can't type if my life depended on it lol.

 

[steved5600]

Most Vw's have a 1.5 bottom limit on resistance. Some of the newer ones go as low as .5 ohms. But if you don't go below 1.5 you can use in on all the ones I know of except for Twist batteries. They are recommended no less than 2 ohms on most. I have a fogger 2 and I still use it sometimes as it is a little more trouble to rebuild than a Kayfun or Russian. The best luck i have had has been with either Twick, a hybrid ekowool cotton wick or with just ekowool. 2.5mm seems to work better and i put on 1-2 1mm top/floating wick to make sure it does not leak or flood. Truth be told i'd get a kayfun before another ver 2 or the v3. FYI the version 4 Fogger is pretty much a kayfun clone. So that may be something to look at.

 

[younglioncity]

fogger 4.0 now... nice and best!!!!!

 

[younglioncity]

pair it with a mechanical mod man