FT praxis copper 1:1 clone review.. sort of.

[bullet08]

pix is on other threads. i like my mech mod easy to use. easy to fire, easy to disassemble, easy to change battery... so far i don't see any of these in praxis. taking out the button, and putting it back was pain. taking the hybrid cap out on first try was pain. trying to find right angle to push in the button and push up is pain. maybe if my fingers are little stronger that might not be an issue.

once set up, it's hits very hard. with origen at .5 ohm, i'm enjoying nice vapes. but every time that mod turns i have to find the button again, then angle my finger just right to push and up. i sort of got used to it. and not much of an issue. but it's not the first mod i would grab if i just want to relax and enjoy the vape.

penny, nemesis, 4nine, cartel.. they are all so much easier to use and clean. but praxis looks nice

 

[Gummy Bare]

pix is on other threads. i like my mech mod easy to use. easy to fire, easy to disassemble, easy to change battery... so far i don't see any of these in praxis. taking out the button, and putting it back was pain. taking the hybrid cap out on first try was pain. trying to find right angle to push in the button and push up is pain. maybe if my fingers are little stronger that might not be an issue.

once set up, it's hits very hard. with origen at .5 ohm, i'm enjoying nice vapes. but every time that mod turns i have to find the button again, then angle my finger just right to push and up. i sort of got used to it. and not much of an issue. but it's not the first mod i would grab if i just want to relax and enjoy the vape.

penny, nemesis, 4nine, cartel.. they are all so much easier to use and clean. but praxis looks nice

How you liking that penny mod? Can you rock super subohm (0.15ohm) on it without the switch getting hot?

Do you know the manufacturer of the penny clone you got?

 

[bullet08]

no clue who makes the penny clone from FT, but i have seen comparison with authentic, and it's almost identical. i like mine a lot. it's 1:1 clone at 23mm. but it will not sit flush with some atties that has long 510. i use it mostly with taifun gt and v2. works well with tobh, but I don't push my battery too hard. .4 ohm is lowest i tried.

 

[Gummy Bare]

no clue who makes the penny clone from FT, but i have seen comparison with authentic, and it's almost identical. i like mine a lot. it's 1:1 clone at 23mm. but it will not sit flush with some atties that has long 510. i use it mostly with taifun gt and v2. works well with tobh, but I don't push my battery too hard. .4 ohm is lowest i tried.

Woh, this whole time I thought the penny mod was 22mm.... Didn't know it was 23mm. What's the issue with the long 510's? Doesn't it have a telescopic adjustable top pin on the mod? Or is it just a little long and could be fixed with some sanding down?

:: sent from android with tapatalk ::

 

[bullet08]

it's basic two screw design. but magma and stillare clones have known long 510. you can sand either the atty or the positive pin on mod, but i like longer 510 in my hybrid mods. and other atties work fine with the penny, so didn't bother. penny being 23 mm, it fits taifun and other 23 mm atties well.