When my G400 paint scratched off [pic 1], I wire brushed with a dremel down to stainless. While removing paint I nicked both ends and had to fabricate new ones. The paint scraper shown provided stock for this.
I usually prefer the stainless look, but it wasn't attractive on the G400. Brown seemed classy. [pic 2]
Using thicker hard plastic allowed drilling a slightly larger 1/16" inhale hole [pic 3].
This G400 stands on either end! [pic 4]
I usually prefer the stainless look, but it wasn't attractive on the G400. Brown seemed classy. [pic 2]
Using thicker hard plastic allowed drilling a slightly larger 1/16" inhale hole [pic 3].
This G400 stands on either end! [pic 4]
