Here is a short tutorial for setting up the Line.
You need kanthal 0.20mm , SS mesh #400 (do not use super fine) , butane torch (You can do it with the lighter but you will get poor results),small scissors and glass of cold water.
Cut the mesh , 3.7cm long and 2.5-2.7cm wide, roll it under your fingers untill you get a firm tube. Cut the bottom part of the mesh at an angle.
This part goes in the tank. Upper half of the mesh burn with butane torch , when it glows put it in the cold water. Repeat this procedure three-four times. Last time you burn the mesh do not drip it in the water, instead use 2 drop of liquid and burn it with your lighter.
Mesh is now ready.
Put a small needle in the mesh , and wrap kanthal wire around it. You will have to wrap kanthal around burned part of the mesh. Use how many wraps you want. 3-4 on 3.7V devices and for more voltage use more wraps. Silver wire should not be in contact with the mesh. Do not wrap it to tight. Tight but not to tight.
Now stick the mesh in the hole between the silver wire contacts on the Line , and wrap it three times around small electrode and three times around bigger electrode. But very tight. Fill your Line through the hole on the thread. Put two drops of liquid on the mesh and burn it.
If the kanthal is glowing put one more drop of liquid on it or move the mesh a little.
If you cant make it to stop glowing you did something wrong. Sorry back to step one.
It should look something like this in the end.
You need kanthal 0.20mm , SS mesh #400 (do not use super fine) , butane torch (You can do it with the lighter but you will get poor results),small scissors and glass of cold water.
Cut the mesh , 3.7cm long and 2.5-2.7cm wide, roll it under your fingers untill you get a firm tube. Cut the bottom part of the mesh at an angle.
This part goes in the tank. Upper half of the mesh burn with butane torch , when it glows put it in the cold water. Repeat this procedure three-four times. Last time you burn the mesh do not drip it in the water, instead use 2 drop of liquid and burn it with your lighter.
Mesh is now ready.
Put a small needle in the mesh , and wrap kanthal wire around it. You will have to wrap kanthal around burned part of the mesh. Use how many wraps you want. 3-4 on 3.7V devices and for more voltage use more wraps. Silver wire should not be in contact with the mesh. Do not wrap it to tight. Tight but not to tight.
Now stick the mesh in the hole between the silver wire contacts on the Line , and wrap it three times around small electrode and three times around bigger electrode. But very tight. Fill your Line through the hole on the thread. Put two drops of liquid on the mesh and burn it.
If the kanthal is glowing put one more drop of liquid on it or move the mesh a little.
If you cant make it to stop glowing you did something wrong. Sorry back to step one.
It should look something like this in the end.
Last edited:
