GG iAtty/ Ato-miser/CE2's Rebuldable Atty's !

[mwa102464]

I started playing around with some different rebuildable Atty's and I started using this XC116 & XC4-116 Wicking material from Omega Corp and also the 400 SS Mesh.

I made an iAtty yesterday using Both the XC4-116 combined with the SS 400 mesh, I put my pin through my XC4-116 wick and took a small piece of the SS-400 Mesh 1/2" of it and placed it right on top pf the XC4-116 with the pin in the XC4-116. I then wrapped my 3.5ohm 36 GA Kanthal wire around BOTH. With the iAtty I bent the piece of mesh down a little bit to allow the cone to cover it, as long as the XC40-116 wick is touching the SS Mesh it works and keeping the mesh wet and also tames it down from using just the mesh like I was using. For those that are using the iAtty your definitely going to want to use this, it is far better then the wicking material that came with the iAtty as well as the newer wicking material being used too. I think it will also work well with the Ato-miser from NHaler, as well with the CE2 Type Cartos if you want to mod them. I'm also finding for me that the XC4-116 is better then the reg xc-116. Just thought some GG iAtty users and people using the Ato-miser & CE2's and any type of re-buildable type of Atty could try this. This combination of the SS 400Mesh combined with the XC4-116 set up it really kicks .... and the flavor of your liquids is so much better

Edit; Another thing I did was opened up the two slits in the ceramic cup enlarging them ! used my Dremel with a special grinding wheel.

 

[blondie1964]

post pictures plz

 

[mwa102464]

Will have to wait until I take apart my iAtty because I have the newest one in it so as soon as I'm done the tank I will post a pick Blondie ! 64 was a great yr, it's my year as well ;-)

PS; The flavor is simply amazing with this set up, all as you taste is your liquids, no wick or burnt anything at all. The Chinese and all vendors should start having there Attys made with this stuff and no one would burn another wick EVER !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Edit: You should pre-burn this wick very good, as well as your Mesh 3-4 times ! I burn each with my butane torch and then clean in PGA and dry.

 

[B-Rad_The_Mad_Vapr]

Shouldn't this post be in the modders forum and not the suppliers forum http://www.e-cigarette-forum.com/forum/atomizer-mods/

 

[mwa102464]

Shouldn't this post be in the modders forum and not the suppliers forum Atomizer Mods

I wanted it in the General Discusion forum, not the modders or Suppliers forum, I must have made a small mistake, a Moderator will move it probably because I can't or would B-Rad,,, Grips looking nice dude

 

[B-Rad_The_Mad_Vapr]

NP... Thanks MWA

 

[atavanhalen]

I have a small amount of this(xc-116) on the way and I am pumped to give it a try. When you talk about preburning it, can you explain a little better on how long or how to do it exactly, also, what is the reason for doing so, does it break it in? Excuse my ignorance.

 

[mwa102464]

The XC wick material is pre-burnt to get rid of the small particles that you could possibly vape up into your throat. I burn mine with a small butane torch that I have but you could do it over a stove if you had to, so ya it breaks it in. I hope this helps and answers your question Atavanhalen