Hey everyone!
Just wanted to post my experience with my new GG4S (SS button).
So, from the first time I got it and put it to use it seemed difficult and hard to press the button with my pinky finger. I had a feeling that something was wrong but never had a bottom button
mod before and I thought I’d be patient and get used to it…
After a few days of using it I realised that if I don’t press the button hard enough the atomiser would still fire a bit and the button would start getting hot. Only when I pressed real hard would the
mod fire properly but it was difficult to do so.
I had been reading various posts here with problems and solutions so I took it apart and assembled it again to see if something was wrong. So, when I unscrewed the screw that compresses the o-ring it unscrewed directly from the button because the part of the screw that compresses the o-ring was very very tightly screwed. I tried to hold the screw with my fingers and unscrew the other part with a screwdriver but it was impossible.
I put it back as it was because I didn’t want to use pliers and damage the finish on the screw and I also thought that if the store assembled it like this they would know better. Not much changed with this, even tweaking the spring or putting it upside down didn’t make much difference but I kept using it like that for a few more days.
Today I felt brave so I thought I’d finally get the pliers and unscrew the screw completely. I did it but I damaged it a bit where i grabbed it. Then I put it back by screwing just enough to compress the o-ring and feel a little resistance but not as tight as it was before.
A miracle! The button started working perfectly! It is so smooth now… It’s even easier than pressing the button on the Esterigon and it fires good and hard without getting hot anymore.
Thanks imeo for this great
device!!!