Glassmanoak's contest #25 with multiple winners and for winners!!

Status
Not open for further replies.

daleron

ECF Guru
ECF Veteran
Verified Member
  • Apr 16, 2013
    21,334
    379,477
    Arkansas, USA
    Post #1.

    Good morning Tree folks :)

    007.jpg
     

    MonicaRae

    Super Member
    ECF Veteran
    3, Good luck,Monica:)

    2 -

    Thanks! I hope I get it -- even if for the fact the training is next week & it'll get me out of 1 week of mandatory overtime. Just sitting here now signing up for my 4 hours/week for the rest of the month. If I don't pick my hours today it'll get randomnly assigned...ughh
     

    Schnarph

    Vaping Master
    ECF Veteran
    Verified Member
    Feb 21, 2013
    4,618
    9,558
    Dripping Springs, TX
    #2 Coffee = good.
    #1 Morning all! :vapor: I just did my first 'rebuild' with cotton!
    Congratulations!

    #2 All I did was just take the silica out of a protank head and thread some cotton from a cotton ball through the factory coil. Seems to be working fine and taste is much better! :vapor:
    Very good! Be prepared to replace the cotton much sooner than silica. May you avoid a dry hit, burning cotton can cause cacophonous coughing!

    3, Good luck,Monica:)
    What she said! ^^^^ ! :)
     

    traderljp

    Vaping Master
    ECF Veteran
    Verified Member
    Aug 16, 2013
    3,022
    1,923
    South Florida
    #2

    I am inspired by all the kanger rebuilding going on here. I have to invest in better 'reading glasses' to start with...the first time I tried to make a coil (for an evod), I couldn't see anything - too little. Gave up on it at that point, but now that I also have a protank, I'm going to take this project up again.

    protank_2_18_500.jpg
     
    Status
    Not open for further replies.

    Users who are viewing this thread