So, I got very much into glass tanks because, frankly, I really like how they look. I first got an Anyvape Mini Davide with my starter kit from Viper Vape (along with a Kanger EVOD Twist 1000 mah) and I like it a lot except that it's kind of difficult to clean, since you have to take it completely apart and putting it back together takes a bit of finesse between threading the top and bottom on to make sure you don't get leaks. So I went looking for something better. Next, I purchased a Kanger Mini Protank 3 and a Kanger EVOD Glass tank. I like the both of them a LOT more thank the Mini Davide except that when I fill them, as soon as I flip them over they seem to only be half full. I also noticed I can't fill them quite as far as the Mini Davide because the post doesn't go all the way up, only part way. I've taken them back apart, re-added more e-liquid and done it again, and suddenly it's only half full again. No gurgling, no leakage, so I'm a bit confused as to where in the world the liquid could possibly be going. Flipping it back upside down doesn't have the liquid going up to the same spot. My main question is whether or not this is normal. It's not a huge problem, they vape well and I really enjoy them, I'm just curious.
I have an RDA that just broke, a 1:1 Trident clone, the middle post had half of the mounting screw break off with very little pressure, the folks at Viper Vape offered to send me their OTHER Trident clone, as I had requested, and even give me a credit for the difference since the other one was a bit cheaper, all without so much as a picture. Pretty awesome customer service. That being said, I'm kind of stuck using these smaller tanks even if I want to use my mod, so I'd like to get the best use out of them possible.
Another question I have is whether liquids could be so thick as to gunk up an atomizer so badly that even soaking in vodka won't clear it out. I don't have any rubbing alcohol to clean it with and I'd seen vodka mentioned. It's a rather dark e-liquid which is amazingly delicious, but if it's going to destroy the tank's atomizers I can just wait until my new RDA arrives to keep vaping it.
Finally, any suggestions of other small glassomizers to try? I'm debating on some of the larger ones for my mod and will probably get a Nautilus and one of the large Aerotanks when those come out, but that's all I've looked into so far.
I have an RDA that just broke, a 1:1 Trident clone, the middle post had half of the mounting screw break off with very little pressure, the folks at Viper Vape offered to send me their OTHER Trident clone, as I had requested, and even give me a credit for the difference since the other one was a bit cheaper, all without so much as a picture. Pretty awesome customer service. That being said, I'm kind of stuck using these smaller tanks even if I want to use my mod, so I'd like to get the best use out of them possible.
Another question I have is whether liquids could be so thick as to gunk up an atomizer so badly that even soaking in vodka won't clear it out. I don't have any rubbing alcohol to clean it with and I'd seen vodka mentioned. It's a rather dark e-liquid which is amazingly delicious, but if it's going to destroy the tank's atomizers I can just wait until my new RDA arrives to keep vaping it.
Finally, any suggestions of other small glassomizers to try? I'm debating on some of the larger ones for my mod and will probably get a Nautilus and one of the large Aerotanks when those come out, but that's all I've looked into so far.